Reconditioning of drawing parts and capstans? RTP Paganoni against wear and signs of time

Degradation and wear of parts are common issues among wire manufacturers. Worn coating of components (cones, pulleys, capstans, rollers, seal rings, wire guides) caused by wire friction and rubbing can significantly compromise performances, affecting the surface wire quality.

Against this backdrop, RTP Paganoni offers a specialized coating regeneration service on worn drawing parts. Even the most deteriorated parts can be restored back to optimum friction condition. The process is carried out by completely removing the worn material and applying a new coating, which will then be ground and lapped by RTP Paganoni's technical staff before being returned to the customer.

Leveraging its years of experience in the field of drawing parts, the company will suggest the best coating based on the type of wire to be drawn. By relying on RTP Paganoni's technical staff, you can further extend your parts’ life cycle, maximizing performance again, and reducing waste, and keeping a keen eye on sustainability as well.

The HDC black ceramic coating is the best known and is ideal for softer wires. For harder wires or those with larger diameters, RTP Paganoni has developed Diamond 3000, the latest frontier in wire drawing coatings. It is an innovative carbide mix with strong adherence on all surfaces. If you are looking for a specialist to level up your drawing performance, do not hesitate to contact RTP Paganoni using the references on the side.

RTP Paganoni offers a wide range of components and spare parts for the processing of ferrous and non-ferrous wires, developed to combat the most common problems of drawing processes, such as wear, abrasion, and corrosion.